IML Connector
Page 13
›
Method 3
a)
Repeat the first 3 steps of Method 2 (see previous page).
b)
With power connected, turn the dock
ON
(at this point, it
doesn’t matter which of the two power states is used).
c)
The IML Connector devices will start their boot up process.
d)
At any stage (users do not have to wait for the devices to
finish booting up), removing the power lead from the dock
will cause the devices to look for radio signal from the IML
Connector Base Station and connect.
e)
As per Method 2, once connection with the Base Station has
been established, the devices will stay turned on.
›
Method 4
a)
Repeat the first 3 steps of Method 2 (see above).
b)
With power connected, turn the dock
ON
(Radio On,
Green/Green power state LEDs).
c)
The IML Connector devices will start their boot up process.
d)
The devices will start charging, however, with the dock in
this mode - they will also connect to an IML Connector Base
Station if available. If an IML Connector device is inserted
into a dock in this state, it will remain connected and will
charge.
With an IML Multidock or IML Minidock in the
Radio On state, the status LED on the IML
Connector device will show the single flash for
charging as well as the double ‘blink’
indicating the device is connected or trying to
connect.
Reminder
Summary of Contents for IML Connector
Page 1: ...IML Connector User Manual...
Page 52: ...IML Connector Page 52 Notes...
Page 53: ...IML Connector Page 53 Notes...
Page 54: ...IML Connector Page 54 Notes...
