34
OPERATIONAL INFORMATION
LED Indicator
Off
On
Red “Power”
Power Off or Not Present
Power On
Red “Charged”
TPU Charging or Not Present
TPU Charged
LED Indicator
Off
Both Blinking
Just One Blinking
Both Solid
Green
“Network”
Lumin Server
Disconnected
Setup Mode. Wi-Fi
connectivity
is disabled. Press
and release
“Setup”
button to exit
(When blue is solid)
Lumin server error
Fully connected
via Wi-Fi
Blue
“Online”
No Internet
Connection via
Wi-Fi
Attempting to
connect to the
Internet
NOTE:
Simultaneous blue and green blinking lights indicate that the LSP is in Setup Mode. This is the
required mode for initial setup and commissioning, however the LSP does not connect to the Internet
via Wi-Fi in this mode. If both lights are seen blinking during normal operation, it is likely that the
“Setup”
button was pressed, taking the LSP offline. In most instances, an additional press-and-release
of the
“Setup”
button will bring the LSP back online. Note that it may take about 45 seconds to restore
the connection and display two solid unblinking indicator lights.
NOTE:
During an Internet outage local connection can be made between an LSP and user's mobile
device as long as the device and the LSP are connected to the same network. Ensure that the LSP is not
in Setup Mode and that Wi-Fi connectivity is enabled on the mobile device.
NOTE:
To manually enable all circuits controlled by Lumin, turn LSP power off,
then on, then off once again. Leave the LSP off and all controlled circuits will
function normally.
Need help?
For additional support documentation, visit
http://luminsmart.freshdesk.com/a/forums or scan the code at right:
