Lumin Smart Panel - Outdoor
DOCUMENTATION AND INSTALLATION MANUAL
33
TROUBLESHOOTING AND REPAIRS
End User
If the LSP is not functioning as expected, ensure that the power switch is on, Internet service is
available, antenna/Ethernet connection is secure, and breakers are switched on. See Operational
Information (pg. 34) on how to read the LSP indicators for Internet connectively status. It is best to
obtain assistance from a qualified installer for further troubleshooting of hardware issues. The
installer’s familiarity with Lumin products and ability to perform electrical work will help resolve issues
effectively. Alternatively, contact Lumin directly for assistance.
Qualified Installer
Observe all safety precautions (pg. 2). Be aware that Lumin app readings may not accurately reflect
electrical conditions, so always assume that the LSP circuits are enabled and conductors are live.
Ensure that the power switch is on, Internet service is available, antenna/Ethernet connection is secure,
and breakers are switched on. Inspect the system for installation and wiring faults (e.g., loose wire
connections). If the issue is not resolved, contact Lumin.
Lumin Certified Installer training is required before Lumin will authorize work on an existing LSP. Case-
specific authorization and instruction will be provided by Lumin if applicable. Do not open cover or
attempt repairs otherwise
—
even with the LSP power switch and main feed breakers off, the Grid
Detection Circuit (GDC) is connected to hazardous voltages.
The LSP power switch does not de-
energize the internal product components.
Fuses: LSP Power
–
non-replaceable 2.5 A; GDC
–
1 A, slow
blow.
DANGER: HAZARDOUS VOLTAGES PRESENT DURING INSTALLATION AND SERVICING. DO NOT OPEN
LSP COVER, INSPECT INSTALLATION WIRING, OR ATTEMPT REPAIRS WITHOUT REQUIRED
QUALIFICATIONS AND LUMIN AUTHORIZATON. ALWAYS DISCONNECT ELECTRICAL SUPPLY BEFORE
PERFORMING REPAIRS.
DANGER: TENSIONS DANGEREUSES PRÉSENTES LORS L'INSTALLATION ET L'ENTRETIEN. NE PAS OUVRIR
LE COUVERCLE DU LSP, INSPECTER LE CÂBLAGE D'INSTALLATION OU ESSAYER DE RÉPARER SANS
QUALIFICATIONS REQUISES ET AUTORISATION DE LUMIN. TOUJOURS DÉBRANCHER L'ALIMENTATION
ÉLECTRIQUE AVANT D'EFFECTUER DES RÉPARATIONS.