luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: CF784-3
10
11
HANGER BALL
PIN
4.5" DOWNROD
SETSCREW
Figure 16
3.16
Route the Three 80” Motor Wires through the Hanger
Ball .
Reinstall the Hanger Ball (Figure 16) on the Downrod
as follows:
Position the Hanger Ball Pin through the Two Holes in
the Downrod and align the Ball so the Pin is captured in
the Groove in the top of the Hanger Ball .
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball .
NOTE: A loose set screw could create fan wobble.
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
WARNING
!
3. Ceiling Fan Assembly
(Continued)
HANGER BALL/
DOWNROD
ASSEMBLY
6 to 9
INCHES
3.17
The Fan comes with Black, Blue and White Wires that
are 80-inches long .
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 17) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
Figure 17
SET SCREW
