U.L. Model No.: CF784-3
8
9
3. Ceiling Fan Assembly
(Continued)
STYROFOAM
PARTIALLY ASSEMBLED
CEILING FAN
Figure 9
3.9
Turn the partially assembled Ceiling Fan right side up in
preparation for final assembly .
Carefully place the partially assembled Ceiling Fan on
the styrofoam being careful not to bend the Ceiling Fan
Blades (Figure 9) .
3.11
Separate, untwist and unkink the Three 80” Motor
Wires .
Route the 80” Black, Blue and White Motor Wires
through the 4 .5” Downrod (Figure 11) .
It is critical that the clevis pin in the motor coupler
is properly installed and the set screws securely
tightened. Failure to verify that the pin and set screws
are properly installed could result in the fan falling.
WARNING
!
THREE 80" MOTOR LEADS (UNTWISTED)
4.5" DOWNROD
Figure 11
3.10
Remove the Hanger Ball from the 4 .5” Downrod by
loosening the Set Screw in the Hanger Ball until the Ball
falls freely down the Downrod (Figure 10) .
Remove the Pin from the Downrod, then remove the
Hanger Ball .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .16 .
NOTE: Do not loosen the screw holding the green
ground wire.
SETSCREW (LOOSENED)
HANGER BALL
4.5" DOWNROD
PIN
GREEN GROUND WIRE
Figure 10
SET SCREW (LOOSEN)
THREE 80” MOTOR WIRES (UNTWISTED)
