Version: 1.4
Date: 16-06-2020
Contact information: for more info please contact the product supplier
Luminext BV | Velperengh 2b | 3941BZ Doorn | Nederland | +31(0)343 420257 | support@luminext.eu | www.luminext.eu
© Luminext BV 2018
2
Installation
1.
Disconnect the power to the Gateway and read the safety instructions above.
2.
Check if the cabinet is suitable for mounting the Gateway and make sure the area is IP65.
3.
Check the Gateway: make sure the Gateway is not damaged.
4.
Directly connect the suitable 868 MHz antenna (Luminext article 40.20.300). Never power the
Gateway without an appropriate 868 MHz antenna connected.
5.
Fix the sma connector with a wrench so this won’t turn loose due to vibrations.
6.
Connect a suitable GSM antenna (Luminext article 40.10.000 ‘haaks’).
7.
If needed, connect external 868 MHz and GSM antennas.
8.
The Gateway is provided with a product label which contains an ICCD number of the present SIM
card of the GSM modem. Ensure that the SIM card is activated.
9.
The product label of the Gateway contains a gateway ID. Ensure that the gateway ID is
administrated in Luminizer.
10.
Mount the Gateway sturdily to the cabinet, e.g. with double side tape. If in doubt contact Luminext.
11.
The Gateway can be used to switch an external load. See wiring diagram below.
12.
Use 1.0 mm
2
wiring for all connections. Push the wires completely into the terminal block and turn
the screws. Use wire end sleeves when using flexible wires.
13.
Mount the antenna with the 3M double sides adhesive tape to the Gateway.
14.
Connect a 230V AC power cable to the Gateway according to the wiring schedule below.
15.
Close the cabinet. Take care that no wires of objects get in between the seals.
16.
Connect the power cable to 230 V AC power and test the correct functioning of the Gateway. In
case of malfunctioning check the wiring.
o
When connect to power the power right LED will lit.
o
When communication with surrounding OLC300S controllers takes place, the centre LED
will lit.
o
When communication with Luminizer takes place, the left LED will lit. This may take
several minutes.
o
Check if the surrounding OLC300S network can be controlled via the Gateway.