Introduction
The ESR.4 receiver is a mains powered mains switching receiver and works in
conjunction with all other products in the easyswitch range.
There are four relays each capable of switching 230 volts 1kw resistive load or 100
watts LED.
This product has a maximum power handling of 8 amps resistive shared over four
relays.
Each relay operates independently and is described as a CHANNEL.
The ESR.4 can learn up to 16 mixed transmitters for each channel.
The memory is non volatile and will not be lost if the power fails.
The ESR.4 will operate up to a distance of up to 200 metres line of sight from any of
the easyswitch transmitters.
TYPES OF TRANSMITTERS:
EST.1
Wireless wall switch. One to three gang.
ESF.1, 2 & 4
Wireless key fob. One, two or four button versions.
ESD.1, 2 & 3
Wireless PIR detector. Choice of three detection patterns.
This example shows one PIR per zone but with a combination of key fobs which will
over-ride the PIR’s. Two of the PIR’s are shown also operating a remote bleeper.
In all. This product will learn 64 devices in all.
ESR.4 & ESR4X4 four channel receiver Installation Handbook
Page 2.
PIR
PIR
PIR
PIR
Bleeper
CHANNEL 1
2 button
Key fob
4 button
Key fob
1 button
Key fob
EXAMPLE:
Fig 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
ESR.4 & ESR4X4 four channel receiver Installation Handbook
Page 3.
EARTHS
1
2
3
4
Remove jumper for single mode
Two way
Mimic
LEARN
1 2 3 4
MAINS
IN
230V
CHANNEL
1
230V
CHANNEL
2
230V
CHANNEL
3
230V
CHANNEL
4
230V
LI
VE
IN
N
EU
T
R
AL
LI
VE
O
U
T
N
EU
T
R
AL
LI
VE
O
U
T
N
EU
T
R
AL
LI
VE
O
U
T
N
EU
T
R
AL
LI
VE
O
U
T
N
EU
T
R
AL
A
E
RIA
L
GROUND
AERIAL CONNECTION:
This product works well using the aerial supplied however there are other types of aerial
available for longer reception range if required. Please contact your dealer for
information.
Unscrew the dome nut on the top of the enclosure and fit the wire aerial supplied.
This aerial must be vertical and point skywards.
Keep the aerial away from large metal objects such as pipes, tanks and even electrical
cables.
If an alternative aerial is required, remove the coaxial cable from the Ground and aerial
terminals as shown and replace with the new aerial cable.
IMPRTANT:
Make sure that the removed cable cannot short out on the circuit board as
this will result in serious injury or death through electric shock.
1
2
3
4
LAMP LOAD
MAX 2KW
230V
LAMP LOAD
MAX 2KW
230V
LAMP LOAD
MAX 2KW
230V
LAMP LOAD
MAX 2KW
230V
MAINS IN
8 AMP MAX
Fig 2
FIXING SCREW.
FIXING SCREW.
FIXING
SCREW.
Screen of
aerial cable
