GX30
-
Globe
Hard Wired PIR Detector Installation Handbook
Page 7.
Contact A polarity
Switch 9
N/O
OFF
N/C
ON
Contact B polarity
Switch 10
N/O
OFF
N/C
ON
Contact B Time
Switch 7
Switch 8
1 second
OFF
OFF
30 seconds
OFF
ON
2 minutes
ON
OFF
5 minutes
ON
ON
Switch setting table
PIR detection range
Detection range can be increased or decreased from 10 metres to 30 metres as preferred.
Increasing the range will also increase the risk of false detection and should only be used
in quiet stable locations.
Where the PIR can detect passing vehicles or pedestrians, it is useful to decrease the
sensitivity which will shorten the detection range.
An alternative solution is to angle the lens down which will keep the same sensitivity but
will be physically limited in range.
Pulse count
The normal pulse count setting is 2 but may be increased up to 4 for environment's where
there is a lot of incidental movement of foliage. Increasing this setting will affect rang.
1 pulse count can be used and will increase range but with a slightly higher risk of false
alarms.
Walk test
Switch this on for a super bright red LED which will assist when walk testing the area to be
covered. This feature may be left on if preferred.
Contact B Day/Night
Switch this on if relay A is only to work between dusk and dawn.
Contact B Time
The contact duration is adjustable from 1 second to 5 minutes for this relay only.
Contacts A and B polarity
Both relay contacts A and B can be independently set to normally closed N/C or normally
open N/O
