LuminoLite CREE XPE Headlamp Instruction Manual
How to replace batteries
1. Lift the clasp on top of the headlamp and open the battery case.
2. Insert the batteries with polarity in correct position. As indicated inside the case.
3. Close the battery case fully until you hear a click.
How to adjust angle of light
–
Hold the headlamp and tilt it downwards up to 45 degrees.
How to change light setting
White CREE:
Press the left button on top of the headlamp (with the light facing away from you). The first
press will activate the main beam (up to 160 lumens). The second press will activate the lower light
setting (up to 40 lumens). The third press will activate the strobe setting. One final press will turn the light
off.
Note:
If white light doesn't turn off ensure that the red LEDs are turned off first.
Red LEDs:
Press the right button to turn the red LEDs on. Press again to activate the strobe setting.
Press again to turn the red LEDs off.
Attention:
Avoid staring at LEDs or shining into a person's eyes. Bright lights can damage your eyes or
the eyes of those around you. RISK OF RETINAL DAMAGE.
