H
Security strap
1)
Once the step is in the
pool secure the platform
to the top seat (see
illustration) using the two
straps provided.
x2
OPTIONAL
:
Once the pool step has been
completely assembled and
secured to the pool, attach the
2 screws supplied through the
platform to the top seat of your
pool to provided a more rigid
assembly.
x2
G
1)
Slowly submerge the step into
the pool. Make sure you do not
damage the pool liner in the
process.
2)
Angle the whole step so that it
is entirely under water. Purge all
the air from under the step.
REV. 02/26/2020 PN:
PG:3
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
1 year on step and ladder.
1 year on hardware.
MANUFACTURER WARRANTY
AQUARIUS 5010 WITH CLASSIC LADDER 6003
J
G
I
1)
Trace a line on each post at 39 inches from the
ground for 48’’ and 52’’ pools. If you have a 54’’ pool,
trace a line at 40.5 inches from the ground.
2)
Slide the pivot blocks onto the posts and line up
with the traced marks. Secure with the screws
provided.
3)
Attach the ladder base to the bottom of the posts
with the screws provided.
4)
Slide the posts through the platform. Slide the lock
over right post between the platform and the handrail.
Secure the platform using the screws provided.
5)
Slide the posts through the handrails. Insert the post
covers into the handrails. If they protrude too much,
raise the handrails until the post covers are seated
securely on the posts. Secure the short handrails in
place with the screws provided.
x18
D
A
D
align for 48''
& 52'' pools
align for 54’’
A
LOCK
1)
Attach the ladder to the pivot blocks with
the bolts, washers and nuts provided.
x2
x2
x2
A
B
C
SWING THE LADDER UP
AND LOCK IN PLACE WHEN
THE POOL IS NOT IN USE
TO PREVENT DROWNING
AND UNAUTHORIZED
ENTRY.
WARNING
Use sliding lock as a guide to drill hole into
ladder in up position. Use a 3/8’’ drill bit with
a cordless drill.
**PADLOCK REQUIRED**
