Page | 2
THIS EQUIPMENT IS SUITABLE FOR USE IN HAZARDOUS LOCATIONS
CLASS I, DIVISION 2, GROUPS A, B, C, D, T3
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN
TO BE NON-HAZARDOUS
AVERTISSEMENT - RISQUE D'EXPLOSION - AVANT DE DECONNECTER
'EQUIPEMENT, COUPER LE COURANT OU S'ASSURER QUE
L'EMPLACEMENT EST DESIGNE NON DANGEREUX
Safety & Installation Instructions
PLEASE READ AND FOLLOW ALL SAFETY INSTRUCTIONS
BEFORE INSTALLING THIS FIXTURE
1.
This fixture should be installed in strict accordance with the National
Electrical Code and any local requirements.
2.
This fixture should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
3.
Do not let power supply cords touch hot surfaces.
4.
Do not use this equipment for other than intended use.
5.
Installation and servicing of this fixture should be performed by
qualified personnel.
6.
Please note that Hi-Power LED’s are very bright; please do not look
directly at LED.
7.
Only install the Fixture using the included bracket as this was specifically
designed for this purpose.
8.
Hi powered LED’s do not get very hot but too much heat can reduce
their rated life, so with this in mind, please ensure that adequate
spacing is provided from heaters, etc and that air can freely flow around
the light.
9.
Ensure that the light is securely fastened to its mounting surface. Please
see the Installation page for mounting instructions.
SAVE THESE INSTRUCTIONS
