SY 220 / SY 250 Light Module Installation Instructions
www.Lumishore.com
Lumishore UK Unit 2, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | Info@Lumishore.com
Lumishore USA 7137 24TH Court East Sarasota, Florida 34243 | (941) 405-3302 | Sales@LumishoreUSA.com
PRESSURE TEST
3
7) Ensure there is no debris or water in either connector. Fit the cable to the back of the light. Ensure that the key on the cable connector, and the
key on the light connector line up. Screw the connector home. The connector should fit easily - DO NOT force the connector.
1) Remove the sealing bolt from the backplate - KEEP THIS SAFE AS IT WILL BE RE-FITTED LATER.
2) Fit the test valve to the backplate, and tighten down to provide a good seal.
Remove the outer bolt
and sealing washer.
KEEP SAFE as it will be
re-fitted after the
pressure test.
NOTE: The pressure test can be carried out with or without the cable fitted.
NOTE: The cable can be fitted at any time. If the cable is not fitted at this stage
ensure that the DUST CAP IS IN PLACE on the back of the light.
