www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | Info@Lumishore.com
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | Sales@LumishoreUSA.com
The locking nut and retaining bolts should be inspected on a regular basis to ensure they are kept tight. LUMISHORE
recommends general inspection of the light module, driver and cable attachments every month.
LUMISHORE lights require simple cleaning. Lights should be checked often to ensure the light body and lens area
are free from sea growth. In the event that your light requires cleaning, we recommend the use of a soft cloth or
soft bristled brush. The glass should be kept clean with a plastic scraper or soft brush. Regular cleaning of the lens
will ensure that the light module delivers maximum optical output. DO NOT use an abrasive cloth or cleaning agent
as permanent damage to the lens may occur.
DO NOT
use any abrasive cleaning materials as these may damage the body of the light.
DO NOT
use any cleaning fluids that contain solvents, acids or alkalis.
DO NOT
clean using pressure washing or sandblasting equipment.
Slight discolouration of body may occur over life. This does not affect performance, and is not subject to warranty.
Due to nature and high build quality it may on rare occasions be possible to see small levels of condensation,
this is normal for high power LEDs and will disappear after cooling and does not harm operation in any way.
No chemicals, cleaners, chemical sprays or sandblasting should ever be applied / used on lights — this will
negate warranty
To prolong device lifetime and prevent marine growth build up, a good quality anti-fouling system must be used to
coat the external body of the device. This should be renewed regularly.
Maintenance and Cleaning
If you have questions or comments, please e-mail info@lumishore.com or call USA (941) 405-3302,
United K44(0)208 144 1694, or 33(0)493 582 537.
Product Support
Maintenance & Product Support
The underwater lighting system should always be tested before the boat goes back in the water. Check that each light comes
on and all lights change in sequence as per the system operation section above. See the problem solving guide for advice on
resolving any issues you may have. Once the boat is back in the water check for any water ingress around the installed lights.
Check again after several hours. Water ingress should be dealt with immediately. The lights should be checked several times
over the first 24hrs and periodically after that to ensure installation is satisfactory.
10