Assembly (Stage 1)
1.
Assemble the four legs by joining the upper and lower legs according to the
same marks (A+A, B+B, C+C, D+D).
(Fig-1)
2.
Screw the four legs into the seat bottom.
(Fig-2, Fig-3)
Do not screw too tight for next step.
1.
Install the two leg supports and footrest by using screws ‘A’, ‘B’, ‘C’ and ‘D’ nuts.
(Fig-4)
a.
Begin by joining the two leg supports using screw ‘C’ and a nut through the
center hole. The holes on the leg supports should extend downwards.
b.
Next, install the footrest onto the front side of chair. Screws ‘A’ (the two longer
screws) needs to pass through the foot rest, then the chair leg and the leg sup-
port before securing with a nut.
The leg support with the “O” marking should be on the left-hand side.
(Fig-5)
Adjust the chair leg by twisting it to align hole for the screw. Finally, attach the leg
supports to the back legs using screws ‘B’ (the two shorter screws) and remaining
nuts.
1
2
3
4
5
9
EN
