9
GB
O R I G I N A L I N S T R U C T I O N S
APPLIANCE FEATURES
The air puri
fi
er is used to
fi
lter the air in rooms. The air is passed through a set of
fi
lters which remove particles from the air. Quiet
and e
ffi
cient work allows uninterrupted operation. The appliance is intended for home use only. The correct, reliable, and safe
operation of the appliance depends on its proper use, therefore:
Read and keep the entire manual before the
fi
rst use of the appliance.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
speci
fi
ed in this manual.
ACCESSORIES
The appliance is delivered complete but requires preparation before beginning operation.
SAFETY INSTRUCTIONS
Recommendations concerning transport and installation
The appliance must be placed on a hard,
fl
at, level and non-
fl
ammable surface. Maintain at
least 20 cm of free space around the side walls of the appliance and at least 30 cm of free
space above the appliance. The location should ensure that the outlet and inlet vents are not
obstructed. No solids or liquids may enter the inlet ports. This can cause damage to the appli-
ance, which can result in an electric shock. Do not place the appliance near gas appliances,
heaters or
fi
replaces. Avoid locations where the appliance will be exposed to direct sunlight
or heat. Do not set anything on the appliance or place any objects over the appliance. Do not
stand or sit on the appliance. It is recommended to set the appliance directly on the ground.
However, if it is placed on other objects, it should not be placed too close to the edge to pre-
vent it from falling. It is forbidden to drill any holes in the appliance, as well as to make any
other modi
fi
cations of the appliance not described in the manual. Disconnect the power cord
from the socket before moving the appliance. Move the appliance by grasping the handle or
housing. Do not move the appliance by pulling on the power cord.
Recommendations for connecting the product to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply correspond to the values shown on the appliance’s
rating plate. The plug must
fi
t into the socket. It is forbidden to modify the plug or socket in
any manner to make them
fi
t. The appliance must be connected directly to a single power
supply socket. It is forbidden to use extension cords, adapters or double sockets. Avoid con-
tact of the power cord with sharp edges, hot objects or surfaces. During operation, the power
cord must always be fully extended and the position of the power cord must be set so that
it does not become an obstacle during operation. The power cord should not be placed in a
manner which would pose a risk of tripping. The power supply socket should be located in a
place where it is always possible to quickly remove the appliance power cord plug. Always
pull the power cord by the plug housing when unplugging it, never by the cord. If the power
cord or the plug is damaged, immediately disconnect it from the power supply and contact
an authorised service centre of the manufacturer for replacement. Do not use the appliance
with a damaged power cord or plug. The power cord or plug cannot be repaired and must
Summary of Contents for 66932
