3.
Unfold the cover completely and
begin to adjust the rear EZ-Clamps
at the rear of the bed. Again,
make sure they are snug but
not
tightened completely.
(Both
front and rear clamps will be
tightened completely in a later step.)
Rotate handle lever down from
its storage position. Adjust
clamps to proper height.
Slide handle lever to edge
of truck bed rail.
Rotate handle lever to locking
position. Repeat for opposite
side.
4.
Shut the tailgate and make sure the cover is centered around the perimeter of the top of the truck bed. Being sure that
the clamps are just snug, you should be able to gently adjust the cover from front to rear or side to side as needed to
center the cover over the bed of your truck.
5.
Once you have the cover in the desired position, pull the cover back into the open position in order to firmly tighten
the front clamps.
When you pull the cover to the open position, it is important to make sure you
secure your rear clamping handles into the lock position to avoid damage to your cover.
Tighten
“Counter Clockwise”
Loosen
“Clockwise”
WARNING:
Prior to vehicle operation, clamps must be secured so
that the clamp’s lips tightly grip the inner bedwall structure.
WARNING:
Rear EZ-Clamps must be locked
in the closed position before folding the cover.
Failure to do so could cause damage to cover.
NON-WARRANTY!
6.
Once you have tightened the front clamps and your Q gaskets are sealed, unfold the cover and make the necessary
adjustments to tighten and secure the rear clamps.
INSTALLATION
INSTRUCTIONS
page 3
CONTINUED
