© PROPERTY OF LUNDIX IT SWEDEN, ALL RIGHTS RESERVED – THE DISCLOSURE OR OTHER COMMUNICATION, COPYING, REPRODUCTION AND ANY USE WHATSOEVER IS FORBIDDEN WITHOUT THE WRITTEN AUTHORIZATION
OF LUNDIX IT.
SPC SmartBox User Manual
Revision
1.1
Page
27 of 62
Reference
2017-110
4.5
Object Database
All automation objects are collected in the Object Database. The objects are divided into following
main categories:
System
. System objects, e.g Automation Mode and global variables.
SPC
. All objects imported from the SPC Panel, e.g alarm areas and zones.
KNX
. All objects imported from the KNX System.
Z-Wave
. All Z-Wave objects.
To look at the objects in the Object Database, go to
System->Object Database
and select the
category you are interested in. Most of the columns are sortable and searchable.
Element
Type
Description
Id
Number
Internal object Id.
Object
Text
Internal object name
Name
Text
Public object name
Type
Text
Type of object (only for SPC, KNX and Z-Wave)
Status
Number
Bitmask with internal status information. (only bit 0 is used at the moment)
Bit 0: 0 = Initialized value, 1 = Uninitialized value
Attribute
Text
For
System
and
KNX objects
the attribute is always ‘value’.
For
Z-Wave
objects the attribute is the same as the command class name, e.g
basic, bswitch, mswitch, meter.
For
SPC Areas
:
mode = Area mode
confirmed = 1 if at least two zones in the area have status Alarm.
alarm = 1 if at least one zone in the area has status Alarm.
tamper = 1 if at least one zone in the area has status Tamper.
NOTE! After restart of SmartBox the object values are marked as uninitialized (or set to default
values) until real values have been collected. Default value for Automation Mode is Home (0) and
for Global Variables 0. All default values are possible to change in the Object Settings Dialog.