Luneau Technology Briot emotion2 Instruction Manual Download

Page: 146 / 162

Maintenance...Messages

5-145

LTO

0x12

Incompatible edger
configuration.
Drilling finishing not
allowed.

The job you have loaded calls
for Drilling finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Drilling finishing.
Load the job again.

0x13

Incompatible edger
configuration.
Grooving/drilling finishing
not allowed.

The job you have loaded calls
for Grooving/Drilling finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Grooving/Drilling fi-
nishing.
Load the job again.

0x14

Incompatible edger
configuration.
Automatic Bevel sub-fi-
nishing not allowed.

The job you have loaded calls
for Automatic Bevel sub-
finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Automatic bevel sub-
finishing.
Load the job again.

0x15

Incompatible edger
configuration.
Bevel curve sub-finishing
not allowed.

The job you have loaded calls
for basic Bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select basic Bevel sub-finishing.
Load the job again.

0x16

Incompatible edger
configuration.
Bevel distance (in mm) sub-
finishing not allowed.

The job you have loaded calls
for Bevel distance (in mm) sub-
finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Bevel distance (in mm)
sub-finishing.
Load the job again.

0x17

Incompatible edger
configuration.
Percent bevel sub-finishing
not allowed.

The job you have loaded calls
for Percent bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Percent bevel sub-
finishing.
Load the job again.

0x18

Incompatible edger
configuration.
Manual bevel sub-finishing
not allowed.

The job you have loaded calls
for Manual bevel sub-finishing.
In the personalisation menus,
you have excluded this parame-
ter.
Therefore the edger cannot ac-
cept this job.

Confirm the message.
If you wish to load this job no-
netheless, change the personali-
sation of the pull-down menus.
Select Manual bevel sub-
finishing.
Load the job again.

Message title

Condition(s) for

display

Action(s)