40
41
Betty R
Betty R
Engli
sh
1 W
brightness level
0.3W Center-LED **
4 W
brightness level
12 W
brightness level
45 W
brightness level
22 W
brightness level
RVLR*
2 W
brightness level
8 W
brightness level
34 W
brightness level
16 W
brightness level
SOS*
28 W
brightness level
alpine emergency*
Customizing the brightness levels
4
4
Press and hold the button
(for approx. 4 seconds)
until one
green LED
lights up.
release the button
The range of brightness levels you can select will
begin automatically
to cycle, as shown below.
Press the button at the brightness level you want.
the
fi rst power-on click
is presented
You have the option to setup to
4 brightness levels
, in any sequence
45 W
22 W
2 W
4.
3.
2.
1.
1.
Default setting
3. brightness level
1. brightness level
2. brightness level
Recover factory settings:
This mode includes an additional slow fl ash mode.
RVLR:
Upon releasing the button,
the sequence
of brightness levels automatically
restarts
, allowing you to set a
second
level
in the same manner as the fi rst click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in
1-step, 2-step,
3-step,-or 4-step modes.
Press and hold the button for 8 seconds, until
5
red
LEDs
turn on.
release the button
2.
3.
Disconnect the battery, and all factory settings will be restored.
Reconnect the transmitter with the lamphead see page 39.
Default setting
*
If in use, shown by green LED
**
Will not be signalised by status LED
In special version with XP-E LED 0.8W
