42
43
Betty R
Betty R
Engli
sh
7
7
Special Functions
Press and hold the button
(for approx. 6 seconds)
until 3
green LEDs
light up.
release the button
Before activating the alternative capacity indicator,
your battery must be
fully charged.
The range of brightness levels you can select will
automatically begin
to cycle, as shown.
The range of battery capacities you can choose
from will
start automatically.
Press the button when the brightness level you
want is presented.
You must approximate the correct range for your
battery; e.g., for an 13.2Ah you would select 14 Ah
(1 red LED)
Similair to our Smartcore batteries the
red LEDs
on the lamphead will now approximatley show the
remaining capacity.
Depressing the button for 3 seconds will initiate
the fl ash mode selected, and the lamp will
continue fl ashing in that mode until the battery
is completely discharged.
2 Ah
4 Ah
6 Ah
12 Ah
8 Ah
16 Ah
20 Ah
3 Ah
5 Ah
10 Ah
7 Ah
14 Ah
9 Ah
18 Ah
3.
3.
2.
2.
1.
1.
Additional beams for special applications
Changing the factory-set SOS function
see page 35
Alternative Capacity Indicator (lamp-head)
Attention!
When the lamp-head is disconnected
from a battery, the indicator will not work correctly
until the battery is fully recharged.
1 W
brightness level
0.3W Center-LED **
4 W
brightness level
12 W
brightness level
45 W
brightness level
22 W
brightness level
RVLR*
2 W
brightness level
8 W
brightness level
34 W
brightness level
16 W
brightness level
SOS*
28 W
brightness level
alpine emergency*
It is possible to change the factory-set SOS signal to
diff erent brightness levels, or to special-purpose RVLR or
Alpine Emergency signals.
Press and hold the button
(for approx. 5 seconds)
until 2
green LEDs
light up.
release the button
Disable indicator
Default setting
*
If in use, shown by green LED
**
Will not be signalised by status LED
In special version with XP-E LED 0.8W
