English
20
21
Piko
Piko
After connecting the lamp to the battery, the software runs a selftest. The lamp itself as well as the
red and blue LEDs in the switch light up once. The
battery voltage
is indicated by the blue and red
LEDs, as follows:
The blue LED fl ashes once for each volt; and then
the red LED fl ashes once for each 1/10 of a volt.
Example:
The LED fl ashes seven times blue and fi ve times red = battery voltage is 7.5 V.
Initialization & voltage display:
more than 8.0 V
battery is fully charged:
7.1 to 7.8 V
battery needs charging
6.5 to 7 V
battery is not ready for use
Interpreting the voltage display:
Operation
Each quick push of the button switches through the dim levels.
Turn on:
Switching:
Turn off :
The fi rst press of the button switches on the light with maximum power. The blue LED is illuminated.
To turn off the lamp, keep the button pressed.
Note:
The light outputs the maximum amount of light only if airfl ow lowers the temperature of the
light suffi ciently. If the light is not cooled by airfl ow, its power is reduced
incrementally
to prevent the
LEDs and electronic elements from overheating.
Meaning of LED colours
Lamp is on high beam.
Lamp is on a lower beam.
1. Battery Warning
, low capacity remaining.
The red LED is lighting.
You can adjust the timing of the battery warning,
see progamming on next page.
2. Battery Warning
, very low capacity remaining.
The red LED is fl ashing and Piko fl ashing ones, too.
Warning!
The red and blue LED fl ashing in turn, the lamp fl ashes 30
times.
Stop immediately!
The light will be switched off .
After switching the light on again, reserve power at a low beam
is available.
When reserve power is completely discharged, the
light will be switched off automatically. So slow down!
Note:
The burn time remaining after the red LED is illuminated
depends on the total battery capacity, the ambient tempera-
ture and the age of the battery.
blue LED lit:
green LED lit:
red LED lit:
red LED fl
light fl ashing once:
blue + red LED
fl ashing in turn +
light fl ashing 5 times:
blue + red LED
fl ashing in turn:
The switch on the lamphead is equipped with a RGB-LED to show informations about
the dim level and the remaining battery capacity.
