Lupine SL F NANO STVZO, Manual

Assembly

As shown in the picture down below, the wire remote should be mounted right 
next to the handle. Then attach the screw with the enclosed allen key size 2.

The remote lights green 



 Low beam is activated. 

The remote doesn‘t light 



 The lamp is switched off or  

      daytime running light is activated. 

The remote lights blue 



 High beam is activated. 

Wired remote

Turn on: 

1.  Activate the light at the display.  

2. Turn it on by pushing the button of the wire remote.

Operation

After turning it on, the lamp lights either with daytime running light or low 

beam (depending on the ambient light). If daytime running light is acti-

vated, you can switch to low beam and high beam by pushing the button 

once.

Keep the button  

pressed 

(let go to  

select)

 until lamp  

lights up

Available 

settings

ECO mode 

Reset to factory settings 

(High beam: 14W, Low beam: 8W, Daytime running light: 2W) 

High beam: 8W 

Low beam: 5W 

Daytime running light: 2W

Lights up 1x

Lights up 2x

Note: It‘s not possible to switch from low beam to daytime running light.  

To do that, you need to turn off the lamp and turn it on again.