5. MEASURING CONSIDERATIONS
Caution :
* Do not apply the overload
voltage, current to the input
terminal !
(1) Ensure that the battery(006 P DC 9V) is connected to
its snap terminal correctly and placed in the battery
compartment.
(2) Before operating this instrument, familiarize yourself
with all instructions that mentioned in this manual.
(3) Always check to make sure that the function switch is
set to the proper position.
(4) Place the RED Test Lead into the proper input terminal
before making measurements.
(5) Remove either of the test leads from the circuit under
test when changing the measurement range.
(6) Do not exceed the maximum rated signal of each range
to the input terminal.
(7) The "Power On/Off Switch" always to the "OFF" position
when the instrument does not use. Remove the battery if
the instrument is not to be used for a long period of
time.
(8) Be sure to slide the "Data Hold Switch" to the off position
(left side) if the data function is not be executed.
7
