Remark :
* If the impedance is larger than 10 K
Ω
, Cp is shown on the display.
* If the impedance is less than 10 K
Ω
, Cs is shown on the display.
* If intend to obtain the accurate value, please test the component
into the " Pin terminals " ( 3-11, Fig. 1 ) or tested via optional
SMD tester, SMDA-22 or SMD test clip, SMDC-21.
Inductance ( Lp/Ls ) : D 0.1
≦
Range
Accuracy
Accuracy
Remark
100 Hz/120 Hz
1000 Hz
20 uH
± ( 1% + 5d )
± ( 1% + 5d )
After calibration
200 uH
± ( 1% + 5d )
± ( 1% + 5d )
After calibration
2000 uH
± ( 0.8% + 5d )
± ( 0.8% + 5d )
20 mH
± ( 0.5% + 5d )
± ( 0.5% + 5d )
200 mH
± ( 0.5% + 5d )
± ( 0.5% + 5d )
2000 mH
± ( 0.5% + 5d )
± ( 0.5% + 5d )
20 H
± ( 0.5% + 5d )
± ( 0.5% + 5d )
200 H
± ( 0.5% + 5d )
± ( 0.8% + 5d )
2000 H
± ( 1% + 5d )
-------------------
After calibration
Range
Accuracy
Accuracy
Remark
10 KHz
100 KHz
20 uH
± ( 1% + 5d )
± ( 1% + 5d )
After calibration
200 uH
± ( 0.8% + 5d )
± ( 0.8% + 5d ) After calibration
2000 uH
± ( 0.5% + 5d )
± ( 0.5% + 5d )
20 mH
± ( 0.5% + 5d )
± ( 0.5% + 5d )
200 mH
± ( 0.5% + 5d )
-------------------
2000 mH
± ( 0.5% + 5d )
-------------------
Remark :
* If the impedance is larger than 10 K
Ω
, Lp is shown on the display.
* If the impedance is less than 10 K
Ω
, Ls is shown on the display.
* If intend to obtain the accurate value, please test the component
into the " Pin terminals " ( 3-11, Fig. 1 ) or tested via optional
SMD tester, SMDA-22 or SMD test clip, SMDC-21.
5
