12
Installation Instructions
Occupant Copy
Adjusting Window Treatment
Settings
Setting Limits
Note:
Entering Limit Setup mode may cause window
treatments to move approximately 203 mm
(8 in.) up or down. Be sure that each window
treatment is positioned so that the fabric can
safely move 203 mm (8 in.) up or down before
entering Limit Setup mode.
To be able to adjust window treatment limits,
your wallstation must have raise and lower
buttons. If your model does not have these,
please contact Lutron Technical Support or refer
to your window treatment documentation to use
the buttons on your EDU to manually set limits.
1. On your shade keypad, press and
hold the top and raise buttons
simultaneously for 3 seconds. The
LEDs next to the top and bottom
buttons will cycle.
Note:
At any time while in Limit Setup mode, you can
move all window treatments together to their
current open limit by slowly double-pressing
the top button, or to their current close limit by
slowly double-tapping the bottom button.
Note:
Once EDUs (electronic drive units of the window
treatment) have been assigned to shade
keypads, limits can be set for an EDU only
using the shade keypad it is assigned to, and a
shade keypad can set limits only for those EDUs
assigned to it.
2. Select the EDU you want to to adjust using the top
button on the shade keypad. Each time you press
the top button, a different EDU that is assigned
to that shade keypad will open and close in an
203 mm (8 in.) range to indicate it is selected.
Press the top button until the EDU for the window
treatment you wish to adjust moves. (You can also
use the bottom button, which moves through the
assigned EDUs in the opposite order.)
3. Adjust the currently selected EDU
to the desired level for the open
limit (the maximum the window
treatment is allowed to open) using
the raise and lower buttons.
4. Press and hold the top button on the shade keypad
simultaneously for 3 seconds to store the current
position as the open limit. The LED next to the top
button will flash quickly for 2 seconds.
5. Adjust the currently selected EDU to the desired
level for the close limit (the maximum the window
treatment is allowed to close) using the raise and
lower buttons.
6. Press and hold the bottom button on the shade
keypad for 3 seconds to store the current position
as the close limit. The LED next to the bottom button
will flash quickly for 2 seconds.
7. Repeat steps 2 through 6 to set the open and close
limits for each window treatment assigned to the
shade keypad.
8. Press and hold the top and raise buttons on the
shade keypad simultaneously for 3 seconds to exit
Limit Setup mode.
