Application Note #734
10
www.lutron.com/support
®
Light Bar Brightness Mode
Adjust the brightness of the LEDs on the light bar in the Active, Light Level Indicator, and Locator Light states .
Select between high-, medium-, and low-brightness of the control’s light bar .
Default Setting: Medium brightness
1 .
Pull
the Front Accessible Service Switch (
FASS
) out to the
open position .
2 .
Press and hold
the
Off
button . (Press the left side of the button to
not mistakenly affect the light bar .)
3 . While continuing to
hold
the
Off
button,
push
the Front Accessible
Service Switch (
FASS
) in to the closed position . Continue to
hold
the
Off
button
for approximately 6 seconds
. The light bar will begin to
flash slowly
(~4 times/second) .
4 .
Release
the
Off
button and
LED 1
will continue to
flash slowly
(~4 times/second) .
Note:
The control will automatically
exit this menu
after 1 minute
of inactivity .
PULL
PRESS AND HOLD
MIN
SEC
PUSH
HOLD
RELEASE
(continued on next page . . .)
