Application Note #734
14
www.lutron.com/support
®
Restore Factory Default Settings
The dimmer can be returned to its original factory settings . This allows the customer a risk-free experience to try
multiple settings .
1 .
Triple tap
the
Off
button
rapidly
,
holding
on the last press .
2 .
Continue holding
until the light bar and the lighting load begin to
raise from low to high
in about 3 seconds .
3 . Immediately
triple tap
the
Off
button again and
release
.
4 . The light bar and lighting load will begin to raise from low to high 3 times, the middle of the light bar flashes, the lights turn
off and then turn back on to high-end .
Default Settings
Feature
Default
High-end trim
Highest level of trim range
Low-end trim
Middle level of trim range
Light level indicator / Locator light
ON /ON
Light bar brightness
Medium brightness
Preset light level
Tapping the
On
button always sets the
lights to full (locked preset at high-end)
1.
TAP
3x
(in <1 sec)
HOLD
(~3 sec)
UNTIL
2.
LOW TO HIGH
3.
TAP
3x
(in <1 sec)
AND
System Features (HRST- and RRST- Models Only)
Note:
If setting up as part of a system, phase settings and low-end trim levels made on the dimmer will be over-written by
the system software .
RRST-PRO-N
- For use in a RadioRA 3 system, please refer to the Getting Started Guide: www .lutron .com/RA3support
Some dimmer behavior features can only be adjusted through the Lutron Designer software .
1 .
Fade ON/OFF rate:
The rate at which the load turns ON or OFF from its previous state .
2 .
Delayed Long Fade-to-Off (DLFTO) Time:
Allows for control over how quickly / slowly the load begins the start of the
dimming sequence . This setting delays the time between when the
Off
button is pressed (normal operation) and when the
lights actually begin the fade-to-off process .
