Lutron Electronics Sunnata HRST-PRO-N, Manual

Application Note #734

4

www.lutron.com/support

®

  Low-End Trim Shortcut

  Default Setting: Middle level of trim range.

1 .  To enter 

Low-end Trim

, 

touch

 the middle of the light bar continually 

for about 6 seconds

 . (DO NOT depress the 

On

 or 

Off

 button .)  

The device will go to low-end and the light bar will begin 

flashing 

slowly

 (~4 times/second) . 

2 .  Remove your finger and the light bar will begin to 

flash quickly

(~8 times/second) indicating the current low-end trim level . 

Note:

 The control will automatically exit low-end trim mode  

after 1 minute

 of inactivity .

3 .  

Slide

 your finger up or down the light bar to set the minimum light 

level (low-end) . The trim setting follows your finger as it is adjusted .

4 .  Once the minimum light level is acceptable, 

Tap

 the 

Off

 button to 

confirm your setting and exit into 

Normal Operation

 . 

Note:

 If at any time you are not happy with the settings you have 

achieved, you may 

Restore Factory Default Settings

 .  

See page 14 for details .

MIN

SEC

1  

Occurs when low-end trim is set too low for a given bulb’s design capabilities, which can  
shorten lamp life .

  This feature minimizes LED bulb flickering and strobing

1

 when the dimmer is at the minimum light level . This feature can 

also be used to set a personal preference .

TOUCH

RELEASE

SLIDE

TAP