Luvele LSVS130G, Instructions Manual

Troubleshooting

P/11

Nothing happens when I try to vacuum package

• 

Check power cord to see if it is firmly plugged into electrical outlet.

• 

Examine power cord for any damage.

• 

See if electrical outlet is functioning by plugging in another appliance.

• 

If your appliance has a mode switch, make sure it is set to the correct mode. 

Refer to the above 

operating instructions

• 

Make sure bag is placed correctly inside Vacuum chamber and beneath the 

air intake.

Air is not removed from the bag completely

• 

To seal properly the open end of the bag should be resting entirely inside 

the vacuum chamber area. 

• 

Check sealing strip and the foam gasket beneath the lid for debris and 

position. Make sure there is no breaking or distortion of the foam seal 

gaskets on both the cover and on the base of the vacuum chamber. Wipe 

clean and smooth them back into place.

• 

Vacuum bag may have a leak. To test, seal the bag with some air in it, 

submerge in water, and apply pressure. Bubbles indicate a leak. Reseal or 

use another bag.

• 

Use only the specified vacuum bag with vacuum channels provided by the 

manufacturer. 

• 

Leaks along the seal can be caused by wrinkles, debris crumbs, grease or 

liquids. Reopen bag, wipe the top inside of the bag and smooth it out along 

the sealing strip before resealing.

• 

There is a vacuum pressure sensor built in this machine. The machine will 

not turn to seal automatically if the vacuum pressure inside the bag is not 

able to reach the predetermined vacuum pressure. Check sealing strip and 

the foam gasket beneath the lid for debris and correct position. Wipe clean 

and smooth them back into place, and try again.

The bag melts

• 

Should sealing strip or sealing element be overheat and melt the bag, it may 

be necessary to lift the lid and allow sealing strip or heating element to cool 

for a few minutes.