Lux Tools 106 542, Manual

11

– Remove the wire bar (17) from the slots 

on either side of the plastic base of the 
collecting bag. Unclip the rubber lip (16) 
of the cloth collecting bag from the wire 
bar. Fold grass collector.

Hook on the grass collector

► P. 5, item 5

– Mount the grass collector (11) as illus-

trated.

Operation

Check before starting!

Check the safe condition of the device:

– Check whether there are any visible 

defects.

– Check whether all parts of the product 

are firmly attached.

– Check that the safety devices are in fault-

less condition.

Setting the operating modes

Adjusting the cutting height

► P. 5, item 6

– Adjust the cutting height as shown in the 

figure.

– Observe the data on the cutting height 

unit.

Attaching the extension cable

► P. 5, item 7

– Hook in the extension cable as illustrated.

Starting the device

► P. 5, item 8

– Press the safety lock (15) and keep it 

pressed.

– Pull and keep hold of the switch-on 

lever (2).

• The product starts up.

Switching the device off

– Release the switch-on lever (2).
• The product stops.

Information on mowing

• Steer the product at an even, slow speed 

(walking pace) in the straightest lines 
possible.

• Always work across slopes where possi-

ble.

• Do not cut wet grass if possible.
• Overlap the mowing lines slightly for an 

even appearance.

Cleaning and maintenance

WARNING! Risk of injury! 

The 

product must only be put into opera-
tion if no defects or errors are found. 
Ensure that any defective parts are 
replaced before the product is used 
again.

WARNING! Risk of injury! 

Always 

pull out the mains plug (disconnect 
the product from its power supply) 
before commencing work on the 
product.

NOTICE! Product damage! 

Only 

cut long grass with the product set at 
it’s highest setting and by repeating 
the working processes until the grass 
is at the required height. This will pre-
vent overloading the product.

NOTICE! Product damage! 

Before 

commencing work always make sure 
that the product has reached its 
maximum speed.

Note: 

When the switch-on lever (2) 

has been pulled and the product is 
running, the safety lock (15) can be 
released.

WARNING! Risk of injury! 

–Always 

keep the extension cable away 
from the product.

– Should a foreign body jam the 

cutter, release the switch-on 
lever (2) immediately.

– If a foreign body gets trapped, 

check the product and have it 
repaired if necessary.

DANGER! Danger of death! 

Before 

any maintenance and/or cleaning 
work:

– Switch off the product.
– Pull out the mains plug.

GB