Lux Tools 115 324, Original Instructions Manual

13

– Please check with your local authority

about the possibilities for correct dis-
posal.

Through separate disposal you send old 
equipment for recycling or for other forms of 
re-use. You will thus help to avoid in 
some cases that damaging material gets into 
the environment.

Disposal of the packaging

The packaging consists of card-
board and correspondingly marked 
plastics that can be recycled.

– Make these materials available

for recycling.

Technical data

*)

The specified values are emission values and do not necessar-
ily represent safe workplace values. Although there is a corre-
lation between emission and immission levels, this cannot be 
used to infer whether additional safety measures are necessary 
or not. Factors which affect the current immission levels at the 
workplace, include the type of room, other sources of noise, 
e. g. the number of machines operating and other processes 
taking place in the vicinity. Permitted workplace values can dif-
fer from country to country. This information is designed to help 
the user to better assess the dangers and risks.

**) The specified vibration emission value was measured in 

accordance with a normed test procedure and can be used in 
order to compare one tool with another. The specified vibration 
emission value can also be used for an introductory evaluation 
of the exposure. The vibration emission value may fluctuate 
from the specified value during actual use of the power tool. 
These fluctuations will depend on the way in which the power 
tool is used. Try to keep vibrations to a minimum. One method 
of reducing the vibration load is, for example, limiting the length 
of time you work with the tool. All parts of the operating cycle 
must be taken into account for this purpose (for example, also 
including times in which the power tool is switched off and 
times in which it is switched on, but is running without load).

***) Special connection conditions according to EN 61000-3-11: 

Only connect the device to a power supply with an impedance 
less than or equal to Z

max

 Contact your electricity supplying 

company if necessary.

Part number

115 324,  115 330

Rated voltage

230–240 V~, 50 Hz

Nominal output

1800 W

Protection class

II

Degree of protection

IP24

Working width

460 mm

Cutting height

30–75 mm

Number of steps

7

Volume of cutting bag 60 l
Weight

26,3 kg

Idle revolutions

3100 min

-1

Noise power level 
(L

WA

)*

9

4

,6 dB(A)

(K = 

1

,

8

 dB(A))

Noise pressure level 
(L

PA

)*

82

,

9

 dB(A)

(K = 3 dB(A))

Vibration**

≤1,89 m/s²
(K = 1,5 m/s²)

Mains impedance 
Z

max

***

0,282 Ω

GB

temp.book  Seite 13  Donnerstag, 5. November 2015  10:07 10