17
– Undo the tensioning screw (29) clockwise
(Caution! left-hand thread!)
– Carefully pull off the clamping flange (30)
and saw blade (31).
Installing saw blade
– If necessary, clean all parts to be assem-
bled before installation.
Removing the saw blade – p. 16
– Installation in reverse order.
Changing the batteries
– Open the battery compartment (14) and
insert the batteries.
Please make sure
the polarity is correct!
– Close the battery compartment.
Storage and transport
Storage
Transportation lock
– Press the unlock push buton (19) and
keep it pressed.
– Slowly guide the tool arm downwards.
– Push in the safety bolts (18).
Transport
– When transporting the power tool, use
only the transport devices and never use
the protective devices.
– Dismantle any components that protrude
from the product.
– Use the original packaging to ship when-
ever possible.
Troubleshooting
If something doesn’t work…
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
DANGER! Risk of injury!
The ten-
sioning screw should not be tight-
ened too tight.
NOTICE! Risk of product damage!
It is imperative to observe the rota-
tional direction of the saw blade and
clamping flange when fitting!
When fitting, make sure that the saw
blade is positioned correctly on the
motor shaft.
NOTICE! Risk of damage to the
unit!
Remove the batteries when the
device is not in use.
WARNING! Risk of injury!
Store the
product so that it cannot be started
up by unauthorised persons. Ensure
that nobody can injure themselves
on the product while it is stationary.
NOTICE! Risk of product damage!
Do not store the product unprotected
in a humid environment.
DANGER! Danger of death!
Improper repairs can result in the
product functioning unsafely. This
endangers yourself and your envi-
ronment.
Fault/malfunction
Cause
Remedy
Motor does not run
No mains voltage?
Check cable, plug, socket and
fuse.
Is undervoltage relay triggered
by temporary loss of power?
Switch on the product once
again.
Motor overheated?
Eliminate cause of the over-
heating, let cool down for a few
minutes, then switch on again.
Tool arm blocked
Safety bolts pushed in?
Pull out the safety bolts.
Release button not pressed?
Actuate release button
(
GB
temp.book Seite 17 Donnerstag, 7. April 2016 9:58 09
Summary of Contents for 380 335
