LUXCANADA.CA
17
TM
BURN HAZARD !
Light bulbs become extremely hot.
DO NOT touch bulbs until they have been switched off and
have cooled. Touching hot bulbs can cause serious burns.
If you need replacement parts, we recommend that you only use genuine parts. Our accessories and parts are
engineered and designed specifically for this series of range hood, with each one rigorously tested to ensure the
utmost in durability and reliability.
REPLACING G4 TYPE HALOGEN LIGHT BULBS
•
This range hood uses 20W 12V (G4) halogen light bulbs.
•
Before replacing a light bulb, make sure the range hood is unplugged or the breaker has been turned OFF.
Do not touch the lights until they have cooled.
•
Place a small flathead screwdriver between light housing and lens cover. Carefully and gently pry up the lens
cover. Remove the old halogen light bulb by pulling in the direction of the wavy arrow as illustrated below.
Do not touch the new light bulb with your bare hands.
•
Reverse the steps to install a new halogen light bulb. After the new bulb has been installed, turn ON the
breaker and the range hood to test that the new light bulb is working properly.
•
CLEANING ALUMINUM GREASE FILTERS / BLOWER SAFETY GRILLS
REPLACING FILTERS
REPLACING GU10 LED TYPE LIGHT FIXTURES
•
The aluminum filters fitted in the factory are intended to filter out residue and grease from cooking. They
need not be replaced regularly but must be kept clean. Filters should be cleaned after every 30 hours
of use.
•
Remove and clean by hand or dishwasher. Spray Formula 409® or equivalent degreasing agent and leave
the filter to soak if heavily soiled. Dry the filters and re-install them before using the range hood.
Drain grease from grease container before the grease and residue overflow.
• Ensure that the Range hood is unplugged or that the circuit breaker is off.
•
Ensure that the lights have cooled. Gently push on the light and turn clockwise all while maintaining pressure
on the light. Insert the new light by turning counterclockwise.
•
Plug in the range or turn the circuit breaker back on and verify the light functions properly.
Worn out filters can be replaced by contacting LUX or an authorized dealer.
A filter with a punctured or broken mesh, or a bent or broken frame, should be replaced.
Summary of Contents for KW30LCD
