OPERATIONS & USE
Air Vent
Mixing Valve
Drain Knob
Hand Spray
POWER Panel
Control Panel
1.
To fill water:
The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa as shown. This is
a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to the temperature
that is desired. The clean jet motor must be completely submerged in water.
C
AUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.
2.
To Auto Fill (Optional)
- With drain open. Turn on water with mixer valve handle.
- Press auto fill air switch (brown & chrome).
- Adjust mixer for desired water temperature.
- Close drain valve, bowl will fill to set water level and shut off.
- Mixer valve is now set open and at temperature setting for the rest of the day.
*Mixer valve must be turned off at the end of the day.
3.
To start whirlpool:
Press the jet button as shown. This will start your Jet motor. You may stop the whirlpool function at any time by
pressing the button again.
The jet button is not labeled in the installation.
4.
To use water spray:
The foot-spa is equipped with a hand held sprayer. To activate the hand shower, pull the hand shower from the
receptacle and depress the thumb control on the sprayer handle. This will turn on the water. When you release
pressure on the thumb control this will turn the water off.
5.
To drain whirlpool tub:
Open the drain plug by turning the control knob as shown.
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
Read and follow all instructions
DANGER
. To reduce the risk of injury, do not permit children to use this unit unless they are supervised
at all times
Use this unit only for its intended use as described in this manual. Do not use attachments that are not
recommended by the manufacturer.
Never drop or insert any object into any opening.
Do not block jets during whirlpool operation.
The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions.
1.
2.
3.
4.
5.
6.
7.
www.luxspachairs.com
www.luxspachair.com
