INSTALLATIONS
Plumbing Connections
3/8 " Hot & Cold Fitting
1” Fitting
Electrical Service
110v, 60Hz, 15 Amp, GFCI protected grounded circuit
s
must be use
d
to supply power
to
each individual
pedicure spa, and the main circuit breaker must be at 25Amp.
M
aximum of two units per each electrical outlet.
Spa Chair Rate : 120VAC, 60HZ, 10A
FAILURE TO ANCHOR THE BASE MAY RESULT IN PERSONAL INJURY OR DAMAGE TO THE UNIT.
DAMAGE AS A RESULT WILL VOID THE WARRANTY.
Discharge pump may be connected to an existing sink floor drain. It can also pump up to 7 ft high, but this will
increase the length of the drain time. The drain connection is at the rear of the unit by a 3/4” fitting.
Gravity drain
uses a standard gravity drain. A floor drain is recommended. Connection via a P-Trap is supplied.
Hot and cold
water supply connections are located at the rear of the unit (4” fittings).
Please be advised that the hot and cold water supply lines are not fitted with optional back flow
p
reventers
unless ordered at initial sale.
Have a qualified licensed electrician install the wiring according to local codes.
The Cleanjets are 1/10 hp, 120V, 1.2 AMP 60OHZ. A 15 amp. GFI protected circuit must be used to supply
power to the unit. The roller back massage chair uses a 115V supply.
Spa
chair
base should be anchored securely to the floor. The base may be anchored through the opening in the
back of the base wherever access is convenient for the installer.
1.
2.
3.
4.
5.
www.luxspachairs.com
www.luxspachair.com
