LUX Royal 550S, Owner'S Manual

1. To fill water:

The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa as shown.This is a pressure

bal-ance valve that requires you to lift the handle to start the water flow and to adjust to thetemperature that is desired. The

clean jet

motor must be completely submerged in water.

CAUTION: DO NOT USE FOAMING, SUDSING OR MINERAL OIL BASED ADDITIVES IN THE WATER.

2. To Auto Fill

 (Optional)

With drain open. Turn on water with mixer valve handle

Press auto fill air switch (brown & chrome)

Adjust mixer for desired water temperature

Close drain valve, bowl will fill to set water level and shut off

Mixer valve is now set open and at temperature setting for the rest of the day

*Mixer valve must be turned off at the end of the day

3.

To start whirlpool:

Press the jet button as shown. This will start your Jet motor. You may stop the whirlpool function at any time by pressing the

button again.

4.

The foot-spa is equipped with a hand held sprayer. To activate the hand shower, pull the hand shower from the receptacle

and

depress the thumb control on the sprayer handle. This will turn on the water. When you release pressure on the thumb

control this

will turn the water off.

5.

To drain whirlpool tub:

Open the drain plug by turning the control knob

as shown

OPERATIONS & USE

Jet Switch

Faucet

Hand Spray

Drain Knob

Exhaust Fan

Control Panel

BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:

1. Read and follow all instructions

2.

DANGER.

 To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all times

3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not Recommended by the

manufacturer.

4. Never drop or insert any object into any opening.

5. Do not block jets during whirlpool operation.

6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.

7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.

Save these instructions

Discharge Pump (Optional)