LUXCANADA.CA
16
TM
USE AND CARE INFORMATION
OPERATION
CLEANING
MAINTENANCE
• Read and understand all instructions and warnings in this guide before operating the appliance. Save this
information for future reference.
•
Always leave the blower safety grilles and the filters in place. Without these components, the blower can
snag hair, fingers and loose clothing.
•
NEVER expose blowers to cigarette ash, ignitable substances or other foreign objects.
•
NEVER leave cooking unattended. Hot oil used in pan frying can easily overheat and catch fire. The risk is
higher when the oil has been used several times.
•
NEVER cook on “open” flame under the range hood. Check deep-fryers during use as super-heated oil may
be flammable.
•
The build-up of greasy residue in the blower and filters increases the chance of fire. Keep the unit free of
grease and residue build-up at all times.
•
Filters must be cleaned periodically and be free from accumulated cooking residue (see cleaning instructions
on page 18). Old and worn-out filters must be replaced immediately.
•
Do not operate blowers when filters are removed; never disassemble parts to clean without proper
instructions. Disassembly should be performed by qualified personnel only. Read and understand all
instructions and warnings in this guide before proceeding.
•
Use two hands to remove filters.
Cleaning the filters and grease container regularly will optimize the range hood’s performance, prolong its life,
and preserve its appearance.
CLEANING EXTERIOR SURFACES
• Clean periodically with hot soapy water and a cotton cloth. Do not use corrosive agents or abrasive
detergents (e.g. Comet Power Scrub®, EZ-Off® Oven Cleaner); do not use steel wool/scoring pads that will
scratch and damage the stainless steel surface. For heavier cleaning, use a liquid degreasing agent such as
Formula 409® or Fantastic®.
•
If (stainless steel) hood looks splotchy, use a stainless steel cleaner to clean the surface of the hood. Avoid
getting cleaning solution onto or into the control panel. Follow the directions of the cleaner.
•
CAUTION: Do not leave the cleaner on too long as this may cause damage to finish. Use soft towel to wipe
off the cleaning solution, gently rubbing away any stubborn spots. Use a dry, soft towel to dry the hood.
•
After cleaning, you may use non-abrasive stainless steel polish such as 3M® or ZEP® to polish and bring out
the lustre and grain of the material. Always scrub lightly, with a clean cotton cloth, and in the direction of the
grain.
• DO NOT allow deposits to accumulate or remain on the hood.
• DO NOT use ordinary steel wool or steel brushes as small bits of steel may adhere to the surface of the
range hood and cause rusting.
•
DO NOT allow salt solutions, disinfectants, bleaches or cleaning compounds to remain in contact with stainless
steel for extended periods. Many such compounds contain chemicals that may be harmful to the steel. Rinse
with water after exposure and wipe dry with a clean cloth.
Summary of Contents for VB30LCD
