ISSUE DATE: FEBRUARY 2018
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: NOVEMBER 2015
APPROVED BY: S. GONZALEZ
PAGE 30 OF 38
PRODUCT INFORMATION MANUAL
SECTION: 12 LUMINETTE PRIVACY SHEERS
Using the PowerView
™
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the PowerView
™
Shade Network” in the
PowerView Motorisation Remote Control Guide
.
Joining a Sheer to a Group
IMPORTANT:
The sheer will not operate using the remote until it has been joined to a group.
1. Press and hold
■
STOP for 4 seconds to put the remote in program mode. The lights on the remote will
flash to indicate it is in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlight for the group number will flash to
show it is selected.
3. Press and hold the manual control button on the motor.
4. While continuing to press the manual button, press
▲
OPEN on the remote. The sheer will move slightly
to indicate it has joined the group. Release the manual control button.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
Basic Operation
1. To wake up the remote, simply pick it up or press
■
STOP. The last group(s) selected will be highlighted
and active.
2. Press “all” or groups 1 – 6 to select the specific sheer(s) to operate. The group button(s) will light to show
they are selected.
a. Multiple group buttons may be selected at a time.
b. To deselect a group, press the group number again. The backlight for that group button will go out.
3. Press
▼
CLOSE to traverse the selected sheer(s) closed, covering the opening.
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Sheer/vane position)
LEFT ARROW
Rotates vanes clockwise
RIGHT ARROW
Rotates vanes counter-clockwise
STOP
(Press and hold for
programming mode)
