082019 Rev. 4
Luxier
4
Installation - Site Preparation
Installation - Drain Assembly
•
Provide sufficient floor support. Check the floor at the installation site and make repairs as
needed.
•
Waterproof the floor is highly recommended. Finished floor must be level.
• Provide adequate clearance on all sides of the bathtub.
•
Minimum of 2 inch waste drain pipe is required.
NOTICE: It is recommended to dry fit the parts before installation.
1.
Place a large drop cloth on the floor to protect the bathtub.
2.
With help, lift the bathtub and place it on its side. Secure the bathtub to prevent it from moving.
3.
Connect the 1 1/2” femail adapter as shown in figure 1. Wrap PTFE tape to the thread on the
drain body and connect the adapter.
4.
Upright the bathtub and carefully move it to the final installation position. (
NOTICE:
Do not drag
the bathtub on the floor as it will damage the bathtub.)
5. Connect the drain assembly to the waste drain pipe. (
NOTICE:
additional connectors and pipes
are needed to complete the installation.)
Drain Body
Flange Gasket
Overflow
Overflow Channel
1 1/2” ABS Female Adapter
(included)
Waste Drain Pipe (not included)
Drain Gasket
Locking Nut
NOTE:
Drain assembly is pre-installed on the bathtub.
Install the included 1 1/2” female adapter first and connect
the drain to the waste pipe. (Additional adapter or pipe will
be required to complete the installation)
Fig. 1
