ZMX
Wireless Transmitter Setup Instructions
www.luxiumlighting.com
11/2017
SETTING UP THE ZMX:
Use these instructions to pair the ZMX transmitter with ZR, ZG or TR series lights that are
configured with Luxium wireless ZMX receivers.
Initial Settings
Setting the lamp to factory conditions:
●
Begin with the power turned off to both the ZMX transmitter and the light.
●
Set DIP switch to desired DMX unit # (all switches off = DMX channels 1-4 = RGBW)
●
Turn power on to the light and plug the power adapter on to the transmitter
●
Make sure that the DMX console settings match the lighting unit address
●
Units are often paired at the factory, so you may be able to start using ZMX
immediately.
Pairing
Pairing the ZMX transmitter with a lamp:
●
Turn on the power to an unpaired lamp that needs to be paired with the transmitter
●
Rotate the selector knob on the ZMX transmitter, one step clockwise, and the ‘>’ should
point to PAIR.
➢
At this point push the knob to get a positive switch click.
➢
The ZMX display will read “Pairing” and will finish the pairing operation in 1
0
seconds.
●
The ZMX transmitter is now paired with the lamp.
➢
Note: multiple lamps can be paired simultaneously.
●
For situations where radio interference may interrupt the signal a channel change
feature is available.
➢
See the section on “Advice for Transmitter use”
Un-Pairing
Unpairing several lamps (with any ZMX transmitter)
●
Turn on the power to lamps, they can be paired or unpaired, it won’t matter
●
Rotate the selector knob on the ZMX transmitter to find the UNPAIR setting
●
Click the knob and wait for the lamps to unpair
➢
If it is desired to globally unpair all lamps, use the UNPAIR ALL setting
➢
If it is desired to unpair only from a specific transmitter, use the UNPAIR setting
●
The lamps will be unpaired within 10 to 30 seconds
Unpairing a Lamp (using DIP Switch)
●
Start with power off to the lamp
●
Set DIP SW to 1011 1100
●
Turn power on to the light
➢
Lamp will flash Lime-Green-Dark in sequence.
●
Lift the rightmost switch
➢
DIP switch setting will be 1011 1101
At this time the lamp flashes red for a few seconds. The unit is now unpaired
