35
Before Asking for Repair Service
While in use, this unit may display phenomena which may be confused as malfunctions. Before contacting your country's official
LUXMAN distributor for repair services, please read the operating instructions for any connected input and output devices and check
the troubleshooting table below. If the cause of the malfunction cannot be identified, please contact your dealer. After LUXMAN’s rep-
resentatives have accepted your request for repair services, inspection fees and transportation expenses may be claimed, even though
the unit may be found to be operating normally.
Besides, such personal computer as a PC/Mac connected to the unit and the software that operates on the PC/Mac (operations and
settings included) are not supported.
Problem
Cause/Solution
Ref. page
No power is supplied even
though the operation button is
pressed.
• Connect the power cable to the AC inlet and the AC outlet firmly.
18
The disc tray comes out even
after the tray is closed.
• Set the disc on the disc tray correctly.
20
• Clean the disc to remove dirt.
2
Playback cannot be performed.
• Clean the disc to remove dirt.
2
• Set the disc on the disc tray correctly.
20
• Remove condensation from the interior of this unit.
1
• Put the disc on the tray with the label facing upwards. (label face
upward)
No sound is generated. / Sound
volume is too low. (Digital input)
• Connect digital cables correctly.
17 - 18
• If the USB is selected as an input source, select this unit (D-03X)
as the output destination by configuring the sound setting of a PC/
Mac.
Refer to the in-
struction manual of
the PC/Mac or the
software in use.
• If the unit (D-03X) cannot be selected even when trying the solution
above, reconnect the USB cable.
• If the USB is selected as an input source, adjust the sound volume
by configuring the sound setting of a PC/Mac.
• If the USB is selected as an input source, adjust the sound volume
on a player software of a PC/Mac.
• Ensure that this unit supports the sampling frequency and the
quantization bit rate of the played back digital signals.
15 - 16
• Check to see whether “UNLOCK” of the digital input is displayed or
not. (When the digital signal from the digital device is not synchro-
nized with this unit, the source may not be played back.)
The remote control cannot be
operated.
• Operate the remote control within the specified operating range.
7
• Replace the remote control battery with a new one.
6
• The remote control infrared receiver is exposed to direct sunlight or
strong light sources (such as inverter fluorescent lights). Change the
installation place or angle to avoid the exposure to light sources.
7
An electronic device such as a
television malfunctions.
• Some devices equipped with a wireless remote control receiver may
malfunction when the remote control of this unit is operated. Keep
this unit away from such devices.
7
Summary of Contents for D-03X
Page 1: ...COMPACT DISC PLAYER D 03X Owner sManual ...
Page 2: ......
Page 40: ...37 MEMO ...
Page 41: ......