20
Before Asking for Repair Service
While in use, this unit may display phenomena which may be confused as malfunctions. Before contacting your country’s official
LUXMAN distributor for repair services, please read the operating instructions and operating instructions for any connected input and
through output devices and check the troubleshooting table below. If the cause of the malfunction cannot be identified, please con-
tact your dealer. After LUXMAN’s representatives have accepted your request for repair services, inspection fees and transportation
expenses may be claimed, even though the unit may be found to be operating normally.
Problem
Cause
Solution
Ref. page
No power is supplied even
though the operation switch is
pressed.
• The power plug is disconnected
from the AC inlet or wall outlet, or
it is not inserted firmly.
• Insert the power plug in the AC inlet
and wall outlet firmly.
15
The platter does not rotate.
• The belt is not wrapped correctly.
• Wrap the belt correctly.
10
• The operation switch is not turned
on.
• Turn on the operation switch.
16
• The start/stop switch is not pressed. • Press the start/stop switch.
16
The Indicator is flashing.
• The rotation speed is not adjusted.
• Adjust the rotation speed using the
rotation speed fine tuning volume
(speed control).
6
No sound is generated
• Connection between lead wires
and the cartridge or between the
headshell and tone arm is incom-
plete.
• Make connections of lead wires
firmly.
Tighten the plug-in nut to secure
the connection between the head-
shell and tone arm.
11
• Connection of the phono cable is
not correct.
• Connect the pin plugs of the phono
cable correctly.
14
〜
15
• Settings or connections of a pho-
no equalizer and integrated ampli-
fier are not correct.
• Check connections between the
devices, power supplies of the pho-
no equalizer, integrated amplifier
and others, the volume position,
selector positions, etc.
The sound volume is too low or
too high.
• The cartridge setting of the phono
equalizer, integrated amplifier and
others is not correct.
• Perform cartridge setting of the
phono equalizer, integrated amplifier
and others in accordance with your
cartridge (MC/MM).
Sound images are shaky, or
sound balance between right
and left is not favorable.
• The player body is inclined.
• Install this unit in a horizontal and
stable place. Use insulators to make
this unit horizontal.
8
、
10
• Anti-skating adjustment is inap-
propriate.
• Perform anti-skating adjustment
appropriately.
13
• The cartridge is not mounted hor-
izontally.
• Adjust the horizontal balance.
12
