Luxman PD-151, Owner'S Manual

6

Names and Functions

1.  Operation indicator

This indicator lights up when the power is turned on.

2.  Operation switch (OPERATION)

This switch turns on and off the power.

 : ON
 : OFF

3.  Start/stop switch (START/STOP)

This switch starts rotating the platter at the selected rotation 
speed.
This switch also stops platter rotation while the platter is 
rotating because this switch serves as both start and stop 
switches.

4.   Rotation speed selection switch 

(33/45/78)

This switch toggles the rotation speed of the platter be-
tween 33, 45 and 78 rpm.
Select a rotation speed in accordance with a record to 
listen to.

5.  Rotation speed deviation indicator

Adjust the rotation speed fine tuning volume to keep the 
indicator lit in green.

6.   Rotation speed fine tuning volume 

(33/45/78 SPEED CONTROL)

Though the rotation speed had been adjusted at the time of 
shipment, make adjustment with each volume in case that 
the rotation speed deviation indicator still flashes even after 
5 seconds have passed from a moment when the start/stop 
switch is pressed.

33:  Align the rotation speed selection switch to “33” and 

adjust to keep the indicator lit in green. 
Align the tip of the provided flathead screwdriver to the 
groove matching with the tip of the screwdriver on the 
volume and then rotate to adjust. 
When the rotation speed is faster than 33 1/3 rpm, 
the indicator will flash in blue. When it is slower than 
33 1/3 rpm, it will flash in green.

45:  Align the rotation speed selection switch to “45” and 

adjust to keep the indicator lit in green. 
Align the tip of the provided flathead screwdriver to the 
groove matching with the tip of the screwdriver on the 
volume and then rotate to adjust. 
When the rotation speed is faster than 45 rpm, the in-
dicator will flash in blue. When it is slower than 45 rpm, 
it will flash in green.

78:  Align the rotation speed selection switch to “78” and 

adjust to keep the indicator lit in green. 
Align the tip of the provided flathead screwdriver to the 
groove matching with the tip of the screwdriver on the 
volume and then rotate to adjust. 
When the rotation speed is faster than 78 rpm, the in-
dicator will flash in blue. When it is slower than 78 rpm, 
it will flash in green.

Be sure to use the provided flathead screwdriver for rotation 
speed adjustment.

When using the screwdriver for adjustment, be careful not to 
scratch the panel with the tip of the screwdriver.

Front panel

6

2

3

4

5

1