Luxor Health 2G series, Operation Instructions Manual

19

18

Method Of Usage

Method Of Usage

Prepare the handle controller frame assembly in step 3.(figure  7)
Insert the handle controller frame assembly in to the cylindrical fixed pipe, be carefully 

that the two groups hole out side and inside should be one to one correspond.(figure8)

( Figure 7)

( Figure 8) 

Prepare two screws which tighten on two sides (figure 9) 
Screw the two screws on two sides make it tighten, finish the installation( figure 10)

( Figure 9)

( Figure 10) 

9.Controller installation and usage

Insert the handle controller in to the frame (figure 1), the frame can turn left and rig ht 
freely. (Figure 2) and the handle controller can swing freely in horizontal direction.

( Figure 1)

( Figure 2)

( Figure 3)

ENLARGE 

FIGURE

Put the cylindrical fixed pipe in to the hole on the right armrest, take care that the 

sthere hole on the fixed pipe should be one to one corresponded with the hole on 
the arm rest of the flange plate. (figure 5)

Screw three screws to tighten it ( figure 6)

( Figure 5)

( Figure 6) 

Note: the gap should be 

face down and vertical to the earth

10.The disassemble and using of pillow pad and back cushion

You can weaken the kneading strength of the neck and shoulder by pillow pad, you 
can use it according to your requirement (Advise you use it). Back cushion connect 
with back by zipper (1), pillow pad connect with the back cushion by fastener (2)

Zipper                                          

Fastener