Luxor Health 2G series, Operation Instructions Manual

15

14

Method Of Usage

Method Of Usage

6.Am rest installation

Find out the plug respond to the arm rest on the bottom of the seat frame, and 

   through out from the square hole which on the fixed steel board.(figure 1)

When the plug out from the square hole on the steel board, respond to every 

   connecting plug( figure 2) 

( Figure 1)

( Figure 2) 

Draw out the plug on the bottom of the seat frame and connect with the arm rest 

joint, air pipe responded to the right place (figure 3)

After connect the responded connector, insert it gently through the square hole on 
the bottom of the seat frame, be careful to avoid to fold the air pipe (figure 4)

( Figure 3)

( Figure 4) 

As figure, the pin on the arm rest respond to the box on the fix board, the steel 

board respond to the groove of arm rest.(figure 5) 

Hold the arm rest with your hands, pin respond to box on the front part of the steel 

board, and pin respond to box on the behind of the armrest,( check the connect 
wire whether it is insert in to the bottom of the armrest frame, avoid to get stuck), 
the whole arm rest covered on the fixed steel board. (figure 6)

( Figure 5)

( Figure 6) 

Note: the connect wire must be 

insert in the right place, avoid to get stuck

Arm rest covered on the fixed steel board, then press the armrest make sure the 

pin into the box on the fixed steel board, and pull it with your hand to check it is 
fasten tightly.(figure 7)

Find out the install hole on the front part of the fixed steel board, screw the screws 

with hex wrench. 

Figure 8

Find out the install hole on the behind part of the fixed steel board, screw the 

screws with hex wrench, finish the installnation, the same installnation of the two 
armrest. (figure 9)

( Figure 7)

( Figure 8)

( Figure 9)

P

R

E

S

S

 IT

D

O

W
N

W

A

R

D

 G

E

N

T

L

Y

Armrest

Seat cushion

Calf rest

Figure: hex head screw 

fixed in front part of armrest 

Armrest  

 back cover

Figure: hex head screw 

fixed in behind part of armrest 

Pull

INSERT INTO THE 

BOTTOM OF 

THE SEAT FRAME

7.

Upper armrest 

installation

( Figure 1)

( Figure 2) 

 Air pipe and trumpet line in backrest cross upper armrest and pipe hole. Two 

    guide pillars of upper armrest insert relevant hole on backrest cover(Figure 1).

Upper armrest pressed tightly by hand. Fixed the upper armrest on armrest 

   cover by two cross recessed pan head screws(Figure 2)