Luxul XMS-1010P, Quick Install Manual

RE

AD 
ME 
FIRS

T

Fold

Fold

Fold

QUICK INSTALL GUIDE

10-Port/8 PoE+ Gigabit  

Managed Switch 

XMS-1010P

Includes:

„

„

XMS-1010P„10-Port/8„PoE+„Gigabit„Managed„Switch

„

„

Rack-mount„hardware„and„rubber„feet

„

„

Power„cable„

SETUP AND CONFIGURATION

1

Physical Installation

The„XMS-1010P„can„be„rack-mounted„or„used„as„a„desktop„switch.„Install„the„
XMS-1010P„in„a„stable/safe„place„to„avoid„any„possible„damage.„Make„sure„
there„is„adequate„space„around„the„XMS-1010P„for„ventilation„and„proper„
heat„dissipation;„Luxul„recommends„at„least„4-6„inches„around„all„sides.„Avoid„
placement„in„direct„sunlight.„Do„not„place„heavy„articles„on„the„XMS-1010P„
and„verify„the„ground„connection„of„the„outlet„is„functioning„properly.

Desktop/Shelf Installation

For„desktop/shelf„installation,„attach„the„four„rubber„feet„to„the„corner„inden-
tations„on„the„bottom„of„the„XMS-1010P,„then„place„the„switch„horizontally„
on„a„solid,„level„platform.

Rack Installation

Use„the„included„L„brackets„for„convenient„installation„in„a„19-inch„server„or„
audio„rack.„As„shown„below,„use„four„screws„to„attach„the„L-shaped„brackets„
on„either„sides„of„the„XMS-1010P,„and„horizontally„insert„the„switch„into„the„
rack.„Use„your„desired„hardware„to„affix„the„switch„supports„to„the„rack.„

          Attach feet for desktop installation                Install brackets for rack-mounting

2

Connecting Ethernet and Power

Ethernet and Power Connections

Use„any„RJ-45„to„connect„the„XMS-1010P„to„an„Ethernet-enabled„device,„„
including„servers,„routers„or„other„switches.„No„crossover„cable„is„necessary.„„
„
The„XMS-1010P„supports„10/100/1000„Mbps„Ethernet;„10/100„Mbps„half/
full-duplex„mode„and„1000„Mbps„full-duplex„mode.„All„ten„RJ-45„ports„
support„Auto„MDI/MDIX„and„can„be„used„as„ordinary„ports„or„as„Uplink„
ports.„Ports„1-8„are„PoE+„and„are„enabled„by„default.„

Use„the„included„power„cable„to„connect„the„XMS-1010P„to„a„surge„
protected„outlet.„The„AC„input„socket„and„a„power„switch„are„on„the„rear„
panel.„The„built-in„power„supply„supports„100~240VAC„at„50/60Hz.„

Network Cabling

Luxul„recommends„Category-5,„super„Category-5„or„Category-6„unshielded„
twisted„pair„(CAT5/CAT5e/CAT6„UTP).„To„ensure„best„performance„and„
stable„data„transmission„at„1000„Mbps,„use„Category-6„shielded„twisted„pair.„

c

CAUTION:

  Multiple Uplink channels can create loops, resulting in 

network failure. Ensure only one Uplink channel exists 
between switches or between the XMS-1010P and a router.

n

NOTE:

  When powering up, the port LEDs corresponding to the opti-

cal interface may take a moment to initialize. This is normal 
as the XMS-1010P initialization and startup completes.

n

NOTE:

  The XMS-1010P has an internal 130W power supply. For 

optimal switch performance, do not exceed 115W combined 
consumption of all external PoE devices.

LEGAL AND REGULATORY INFORMATION

No„part„of„this„publication,„or„any„other„publication„may„be„modified„or„

adapted„in„any„way,„for„any„purposes„without„permission„in„writing„from„

Luxul.„The„material„in„this„manual„is„subject„to„change„without„notice.„Luxul„

reserves„the„right„to„make„changes„to„any„product„to„improve„reliability,„

function,„or„design.„No„license„is„granted,„either„expressly„or„by„implication„

or„otherwise„under„any„Luxul„intellectual„property„rights.„An„implied„license„

only„exists„for„equipment,„circuits„and„subsystems„contained„in„this„or„any„

Luxul„product.„

FCC Compliance

This„device„complies„with„Part„15„of„the„FCC„Rules.„Operation„is„subject„

to„the„following„two„conditions:„(1)„this„device„may„not„cause„harmful„

interference,„and„(2)„this„device„must„accept„any„interference„received,„

including„interference„that„may„cause„undesired„operation.

Hereby,„Luxul,„14203„Minuteman„Drive,„Suite„201,„Draper,„Utah,„

84020,„declares„that„this„Luxul„XMS-1010P„is„in„compliance„with„the„

essential„requirements„and„other„relevant„provisions„of„Directive„

1995/5/EC.
For„a„copy„of„this„report„send„a„self„addressed„stamped„envelope„„

to:„Luxul„CE,„14203„Minuteman„Drive,„Suite„201,„Draper,„Utah,„84020.

Industry„Canada„(RSS-Gen„Issue„4)
CAN„ICES-3(B)/NMB-3(B)„

Sales

P:„801-822-5450„

E:„sales@luxul.com

Technical Support

P:„801-822-5450„Option„3„

E:„support@luxul.com

© 2016  Luxul. All Rights Reserved.  LUX-QIG-XMS-1010P 0161609