Quick Install Guide
XMS-2624P
14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-QIG-XMS-2624P 016150909
6
XMS-2624P INSTALLATION
Installing the XMS-2624P in a Rack
The XMS-2624P can easily be installed in a standard 19” rack. The XMS-2624P includes
two mounting ears for installing and stabilizing the switch. When attaching the
mounting ears and installing the switch within a rack, please refer to the following
illustration:
Rack-Mounting the XMS-2624P
Using the included screws, attach the mounting ears to each side of the switch.
Mount the switch in the rack with the LEDs facing outwards. Be sure the switch is
level and properly secured within the rack.
Desktop Setup
For use as a desktop device, position and apply the included rubber feet to the
bottom of the XMS-2624P.
Attaching the Rubber Feet to the XMS-2624P
Network Connections:
The XMS-2624P supports 10/100/1000 Mbps Ethernet; 10/100 Mbps half/full-
duplex mode and 1000 Mbps full-duplex mode. All RJ-45 ports support Auto MDI/
MDIX and can be used as ordinary ports or as Uplink ports. Any RJ-45 port can be
used to connect the XMS-2624P to an Ethernet enabled device (including servers,
routers, and other switches) without a crossover cable.
The XMS-2624P offers 2 shared optical module expansion ports. Once the Gigabit
SFP optical modules are inserted, these interfaces can support optical fi ber cables
to extend the Gigabit network—enabling the network to reach beyond the 300
foot limitation of twisted pair Ethernet.
