IAD SERIES USERS MANUAL
26
4.1.1 Uplink mode setup
Select<Network> and <Basic Setup> then <Upmode>, and the <Upmode>page pops up as
the following as figure4-1.
Figure 4-1 Uplink mode setting
Under ethernet upmode,the Wan port of the device serves as the uplink Ethernet interface, which supports the
hybrid mode of TAG and UNTAG under the sub-interface mode.
4.1.2 LAN SETUP
Select “Network” and select<Basic Setup> and <Lan Setup>, the Lan settings page will display as follows:
Configure the IP address and subnet mask of the LAN port. The system has a default IP address of 192.168.200.1
and a subnet mask of 255.255.255.0.
Figure 4-2 Lan Setup
After modifying the LAN port IP, you need to log in to the new device address to continue the configuration;
4.1.3 WAN setting
