IAD SERIES USERS MANUAL
44
Figure 4-21 Network USB configuration
The setting instructions of network usb flash drive are as follows:
Table 4-21 network U disk Settings
Terms
Description
USB
connection
status
The product's USB interface is attached to the
storage device, showing "USB connected";
otherwise, it shows "USB not connected".
Before pulling out the USB drive, please click < pop
up the USB drive > button, and then pull out the USB
drive after the status update is "USB is not
connected".
FTP setting
FTP Sharing
Settings
Select “FTP service”,the intranet users can access to
the usb device by entering “ftp://local lan port
address” in the browser.
Select “Enable accessing from WAN side”,it is
allowable for the WAN side users to access usb
device by entering “ftp://product local wan port
address” on the browser.
“Enable communication encryption”: select this to
enable the communication encryption.
Server port
FTP server port,generally set “21”
Access to
FTP Shared
U Disk
Click accessing here ,it can visit the shared u disk.
