IAD SERIES USERS MANUAL
59
NoAnswerTimer
After the user dials,set how long there is no answer
and play the prompt tone.
fxs_pch_time
Judge the patting fork action of the user, and it is
considered to be the patting fork action within the set
time range, and it is considered to hang up if the time
exceeds the set time. It is recommended to keep the
default values.
Digiphone_code
58426
Digiphone_second_code
58427
hot_line
*53#
SipUserNum
SIP user increased
Short switch
Use to turn on the switch between short number
switch,the internal number can be dialed within the
IAD.
Long Switch
Use to turn on the switch between long number swtich,
SIP user number can be dialed by external device with
this switch on.
Basic information
FaxMode
Select the fax mode, “T.30 pass through” “T38” or
“no”
PolaritySwitch
Select whether to enable polarity reversal. Enable this
function. When the phone is connected, provide a
reverse polarity signal.the phone billing starts billing,
the default value is “off”,reflects not turn on this
function.
TransmitGain
The transmission gain of the line is selected to adjust
the strength of the transmitted signal. The effective
parameter setting range is from -8 db to 8 db. The
default value "0 db" does not change the signal
strength.
ReceiveGain
The receiving gain of the circuit is selected to adjust the
strength of the received signal. The effective parameter
setting range is from -8 db to 8 db. The default value "0
db" does not change the signal strength.
EchoCancelStatus
Select whether to enable echo suppression.
5.8 Digitmap
The dialing rule is the number acquisition rule descriptor, which is used to detect and report the dialing events
received by the terminal. The main purpose of using dialing rules is to improve the efficiency of this product to
